Safety Instructions - erba 33229 Mode D'emploi

GB - INSTRUCTION MANUAL

1. SAFETY INSTRUCTIONS

Read this material before using this product. Failure to do so can result in serious injury. KEEP THIS
MANUAL. When giving this machine to third parties, always include this manual. We do not accept
any liabilities for accidents or damages that result from misuse. Removal/Alteration of any
safety devices or of the machine in general will result in the loss of warranty. The
buyer assumes all risk and liability arising out of his or her repairs/alterations to the
original product or replacement parts thereto, or arising out of his or her installation
of replacement parts thereto.
Always keep your work area well lit, clean and free of obstacles.
Do not use the product in the vicinity of ignition sources.
Keep children away from your work area.
Avoid contact with grounded surfaces (eg. pipes, radiators, etc.) to avoid the risk of electric shock.
Do not use the product in moist or wet areas.
Never carry the product on its electric cord. Do not pull the cord to unplug the product. Check
the cord for any damage on a regular basis.
When using the product outdoors, always use suitable outdoor-extension cords/outlets.
Always use propper personal protection equipment (eye-protection, gloves, etc.).
Make sure the product is turned off when plugging in the cable.
Do not wear loose clothing, jewellery or any other accessory that might get caught in the ma-
chine. If you have long hair, wear a hair-net.
Always disconnect the powercord when doing maintainance work, cleaning or changing the tools.
Never leave the product unattended when children are present.
Check the product for any sign of damage each time before you use it.
Do not attempt to repair the product when it is damaged! Repair work must only be done by
authorized, qualified service technicians.
When using extension chords, make sure to use only cables with the propper diameter
(3x1,5mm). Do not use adapters or powerstrips.
When using the „chisel/hammer" mode, press the chisel against the workpiece BEFORE starting
the machine. Chisels may be ejected from the machine otherwise.
Always use the auxilary handle and operate the machine with both hands.
Use a detector to make sure not to drill/chisel into any gas-, water- or powerlines!
Never switch between drill and chisel mode when the machine is running!
Only apply axial (along the axis of the drill/chisel) pressure while working! Lateral/angu-
lar pressure may cause the drills/chisels to break!
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 11
Changes, print, punctuation and other errors reserved!
Instruction manual
33229
Issue: 02/2017