Cable Splicing - Lorentz PSk2-7 Manuel D'installation Et De Fonctionnement

38 Pump Installation
For surface pumps:
Figure 18: Prevent air locks in pipes
Figure 19: Avoid sharp 90° elbows and size adaptors

9.1.2 Cable Splicing

To connect the motor cable with a cable extension you
should connect the cable ends with a splicing kit.
It is very important that the cable joints are fully sealed oth-
erwise moisture could cause a short circuit. This will damage
the pump system.
For more information about connecting cable ends with a
splicing kit see the "submersible cable splicing" manual in
the package of the splicing kit.
CAUTION – Cable splice failures are a
common source of errors. Check the splice
for proper connections.
CAUTION – Bad cable splicing can damage
the controller and/or the pump. Such
damage is excluded from the warranty.