CRH Leviat HALFEN FPA-3 Notice D'utilisation page 4

HALFEN FPA
Installing the bottom cast-in support in the precast panel
1
Angle bracket
Polystyrene
recess former
2
On-site reinforcement
3
4
The bottom cast in support FPA-3/5-E consists of an U-bracket, an angle bracket
and a polystyrene recess former, delivered preassembled.
U-bracket
Insert the reinforcing stirrups, through the provided holes,
dimensions according to the table.
Bottom cast in support - additional reinforcement dimensions [mm]
Load range
d ,
s E
e
l
E
Ø i
E
Fix the cast-in support with nails to the formwork. Nail holes are provided in
both, the U-shaped bracket and in the angle bracket.
Note: Auxilliary construction must be fl ush with the
→ upper concrete edge = lower edge of auxilliary construction
Wooden auxilliary
construction
Upper concrete edge
l
E
d ,
s E
60°
for load range 34,0 to 56,0
e
5,0 8,0 11,5 16,0
6 6 8 8
– – – –
250 250 250 350
24 24 32 32
Upper concrete edge
© 2021 HALFEN · INST_FPA 09/15 · www.halfen.com
Assembly Instructions
Ø i
E
22,0 34,0 46,0 56,0
8 10 12 12
– 25 42 52
400 500 500 600
32 40 48 48
angle bracket surface!