Hema 80.06.0018 Mode D'emploi page 34


If the thread had tangled or jammed, please turn the hand wheel and simultaneously pull the thread
slightly to release the thread. Bottom bobbin mechanism is a more precise part, inappropriate
actions may damage it. Please to not push or pull it by finger or any tools.
FEATURES
1. Selection of stitch pattern
Rotate the pattern selection dial to select one pattern you want from the 12 stitch patterns. There are pattern
illustrations on the surface of machine body for your reference.
Caution:

Before you change the stitch pattern, please turn off the switch and turn the hand wheel to raise the
needle all the way up so it doesn't get stuck and bent.

Changing the stitch pattern is not allowed when the machine is running, otherwise the needle and/or
machine may damage.
2. Reverse sewing
Reverse sewing (back stitching) is useful for reinforcing the beginning and end of seams. To use this function
proceed as follows:
1) Sew forwards as normal, and then press and hold down the reverse stitch button on the front of the
sewing machine to sew backwards.
2) To sew forwards again simply release the reverse stitch button.
Note: Reverse sewing is applicable only to stitch patterns 1 to 4.
3. Setting the sewing speed
Slide the power switch to "L" or "H" position. ("L" = low speed; "H" = High speed)
4. Working lamp
If additional light is needed, press the light switch to turn the light on. Press the switch again to turn it off. The
working lamp cannot be replaced yourself.
5. Thread cutter
The machine has a thread cutter on the central left side of the machine, it can cut off the thread after sewing
- 33 -
Fig.11
Fig.13
Fig.12
Fig.14
80.06.0018