ALPHA-TOOLS PS 520E Instructions De Service page 9

Anleitung PS 520 E AlphaTools
1
Changing the saw
blade
Insert the saw blade in the
ram up to the stop and
tight the screw of the
retention clip.
Important: Make sure that
the saw blade sits pro-
perly in the slot of the rol-
ler and ram.
Releasing the saw blade:
Turn screw anticlockwise.
2
Locking button
On/Off switch
Switching on: Press the On/Off switch
Continuous operation: Lock the On/Off switch with the
locking button
Switching off: Press the On/Off switch
and release
3
Turn the speed controller to increase the
cutting rate
06.09.2005 15:16 Uhr Seite 9
4
45°
30°
15°
0°
Undo the two screws to set the base to an angle of up to
45° on the right or left side.
Cutting veneered chipboard:
5
1. Use a fine saw blade
2. Position the base on the uncovered area
3. Advance the saw with little force
Support
Cutting holes: Possible only in chipboard and wood unless
you drill a hole first. Press the jigsaw firmly against the
support and move slowly in cutting direction.
GB
45°
30°
15°
0°
9