BST DSP12A Manuel D'utilisation page 5

The «LINK OUT MODE» switch enables the user to select whether the mixed signal (on the DSP box) will
be played in stereo or mono on the original and linked speaker. The following signals are mixed and output
according to the switch setting.
LINK MODE switch
Input of the first DSPxxA box
Output of the first DSPxxA
box
Output of the linked DSPxxA
box
5. DSP PRESETS PANEL SECTION
This section allows to match the speaker's response to the relevant applications. Press the PRESET switch
and scroll through following modes:
LIVE: The ideal preset for most «live» applications
DJ: Recommended for installations in discos and clubs
SPEECH: the speaker allows the best speech intelligibility
MONITOR: The speaker becomes specially suited for use as a stage monitor.
The selected mode will be indicated by the related LED.
6. FRONT LED SWITCH
This switch allows to switch the blue front LED ON/OFF
7. LIMIT INDICATOR (LED)
This red LED indicates that the limiter has been triggered because the output voltage of the amplifier exceeds
the maximum level, or because a power overload has been detected. It is normal that this LED flashes occa-
sionally but if it stays on for a longer time, please lower the input level.
8. HPF SWITCH
This switch allows to select the cut-off frequency of the high-pass filter. Placing this switch to ON (120Hz)
will cut the low frequency components below the threshold. If the unit is used independently, the switch must
remain in OFF position. If you intend to use the unit in combination with a subwoofer, we recommend that you
set this switch to 120Hz.
STEREO
INPUT 1 INPUT 2/3
L
√ √
√ -
EN • DSP12A / DSP15A • 5
MONO
INPUT 1
R
-
√
INPUT 2/3
L R
√
√