How To Use - Metabo HPT WR 16SE Mode D'emploi

HOW TO USE

1. Operation of switch (Fig.3)
The switch in this machine functions
as a motor switch and rotational direc-
tion selector switch. When the switch
is set to R indicated on the handle
cover, the motor rotates clockwise to
tighten the bolt. When the switch is set
to L, the motor rotates counterclock-
wise to loosen the bolt. When the
switch is released, the motor stops.
CAUTION:
Be sure to turn the switch OFF and wait until the motor completely stops be-
fore changing the direction of wrench revolution. Switching while the motor is
rotating will result in burning the motor.
2. Tightening and loosening bolts
A hex. socket matching the bolt or nut must first be selected. Then mount the
socket on the anvil, and grip the nut to be tightened with the hex. socket. Hold-
ing the wrench in line with the bolt, press the power switch to impact the nut for
several seconds. If the nut is only loosely fitted to the bolt, the bolt may turn with
the nut, therefore preventing proper tightening. In this case, stop impact on the
nut and hold the bolt head with a wrench before restarting impact, or manually
tighten the bolt and nut to prevent them slipping.
3. Tightening Mode Switching Function (Fig.4)
Each press of the High-Low Switch cycles through 4 varying levels of tightening.
Depending on the task, use this mode to adjust the tightening strength. (Table 1)
High-Low Switch
High
Low Medium
Fig. 4
High-Low
Indicator Lamp
Maximum
English
Switch
Fig. 3
9