Tank Cleaning - IARP KREA Instructions D'emploi Et D'entretien

For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: wash with warm water and mild detergent, rinse well and dry with
soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: only use products specifically designed for glass cleaning; it is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
DEFLECTOR GLASS
Place the deflector glass with
writing 'TEMPERED' on left side.

TANK CLEANING

For a periodical tank cleaning, proceed as follows:
1) Place the product in special refrigerated containers, kept at the same temperature.
2) Unplug the unit.
3) Before cleaning the tank the inside temperature must be equal to the ambient temperature.
4) Carefully wash the tank with water and neutral soap; rinse and dry well.
5) Plug in again and wait till the appliance reaches the right temperature before filling it again.
Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process, other than
those recommended by the manufacturer.
SEASONAL USE
When the unit is not used for a long time, please take note of the following procedures:
-unplug the unit;
-clean and dry the tank well;
-leave the tank open to avoid possible formation of bad smells;
-cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
-17-