brennenstuhl RCS 1044 N Manuel D'utilisation page 19

4. Press any key on the remote control (4). The function indica-
tor light (5) illuminates when the key is pressed.
3
If the function indicator light (5) does not light up when a
key is pressed the device is not receiving any power from
the battery. Check whether you have inserted the battery
correctly.
Synchronising the system code
Before the devices can be used for the rst time the system
code must be synchronised to enable all socket switches to
react to the radio signal of the remote control.
Moreover, each socket switch must be assigned a key pair on
the remote control to enable it to be operated
individually.
3
Adjust the DIP switches using a suitable object, for
instance a small screwdriver, by pushing them down or
up.
Setting a system code on the remote control
1. Open the cover (7) of the battery compartment (9).
2. Set any system code using DIP switches 1 to 5 (10).
3. Close the battery compartment (9).
19