25 _ Appliance Preparation - FarmaMed Nébulisateur portatif avec technologie Mesh Instructions D'utilisation

This nebuliser can operate either on two replaceable AA alkaline batteries (not provided)
or using the USB cable (provided) connected to a power supply unit (not provided).
The power supply unit must satisfy the following parameters:
•
input voltage: 100-240 V AC, 50/60 Hz;
•
output voltage: 3-5 V DC,1-2 A;
•
do not use at the same time batteries or USB cable: use only one of the two.
1) Use with batteries
•
Open the battery compartment by pressing down on the lid (Fig. 5).
•
Insert the batteries as indicated.
•
Close the battery compartment.
2) Use with the USB cable provided
This appliance can be operated using the USB cable provided.
•
Remove the batteries;
•
connect the cable to the socket;
•
connect the cable to the power supply unit (not provided).
Note: Check that the output port of the power supply unit matches the AC power supply
required.
To guarantee safe use, use a power supply unit that meets electrical safety standard IEC 60601-1.
APPLIANCE PREPARATION
Fig. 5
EN
25