Every Month - Hagen Fluval chi Mode D'emploi

EN

EVERY MONTH:

CHECK YOUR SUPPLIES of food, water
conditioners, media and other regularly
used items.
RINSE FOAM PAD - For best results,
replace every 2-3 months.
REMOVE, CHECK AND CLEAN IM-
PELLER AND IMPELLER WELL
Note: Filter Maintenance:
WARNING: ALWAYS DISCONNECT
APPLIANCES IN THE AQUARIUM
FROM THE ELECTRICAL SUPPLY
BEFORE PLACING HANDS IN THE
WATER.
How to Replace Filter Pads
a) Unplug the transformer from the
electrical outlet.
b) Remove filter cube dome top
c) Fully rotate cube 180° counter
clockwise so that the filter cover is
pointing upwards (ill. J).
ill. J
d) Lift open filter cover.
e) Pull tag to remove filter pad (ill. K).
ill. K
f) Remove foam pad if necessary (ill. L).
ill. L
g) Replace foam pad first then filter pad.
h) Close filter cover, ensuring that it
clicks. If you do not hear a click, then
verify that the filter pad and foam are
correctly positioned.
How to Care For the Impeller
and Motor
It is recommended that you remove the
motor and clean the impeller every 6
Months or if the filter stops or flow is
reduced.
Keeping the impeller clean lengthens
its life and the life of the motor.
a) Unplug the transformer from the
electrical outlet.
b) Remove pebble basket or décor
tray if any are positioned on top of the
filtration cube.
c) Remove filtration cube from the
aquarium.
d) Remove filter pad and foam pad.
e) Remove grill housing (ill. M).
ill. M
f) Remove impeller cover (ill. N).
ill. N
g) Remove impeller (ill. O).
ill. O
h) Rinse it under clean water. NEVER
use soap or detergents, as traces
Clean inside the impeller well with
a cotton bud and rinse.
protected against water penetration,
and can safely be washed or
submersed in water without
concern.
i) To replace, re-install impeller and
impeller cover.
j) Replace grill housing, filter pads
and close the cover.
k) Replace filter cube on aquarium,
and plug filter back into power outlet.