UBERHAUS DESIGN Sonoma Guide De L'utilisateur page 7

Attach one end of the left long support beam of top long side (D3) onto the middle beam of top (C3) with Bolt
Fig.15:
(DD) & Large flat washer (BB).
Attach the other end of the long support beam (D3) onto the top slanting bar (B3) with bolt (DD) & washer
Fig.15-1:
(BB). Use the same way to assemble E3, F3, G3, H3, I3, J3, and K3 respectively.
Screw the pothook (L3) to the connector of Top frame (A3).
Fig.16:
Hardware Pack 4
BB
Φ1/4" Large flat washer
DD
1/4"-20*0.6 Bolt
GG 1/4"-20*1.6 Bolt
JJ
1/4"-20*1.38 Bolt
Fig.17: Press left roof cover of long side 1 (B4) to the right roof cover of long side 1 (C4) as shown above.
Fig.18: Install Roof cover of short side 1(H4), Right roof cover (long side) 1 (C4) & left roof cover of long side 1
(B4) onto the Top slanting bar (B3) with Bolt (DD) & Large flat washer (BB).
Fig.19: Attach the roof covers B4,C4, D4, E4, F4, G4, H4, J4, K4, L4 to the Top slanting bar (B3) with Bolt (DD) &
Large flat washer (BB).
Fig.20: Press up the roof covers with the Roof press sheet (A4), and fix A4 on the decorative beam with Bolt (DD)
& Large flat washer (BB).
52 PCS
42 PCS
8 PCS
2 PCS