Hardware Pack - UBERHAUS DESIGN Sonoma Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Hardware Pack 1

AA
1/4"-20*1.25 Hex bolt
BB
Φ1/4" Large flat washer
CC
1/4"-20*0.6 Hex bolt
KK
Ring (Pre-assembled)
LL
Clips (Pre-assembled)
Z
Φ1/4" Wrench
Fig.1
I nsert Long left decorative beam 2 (Short left decorative beam 2) B1 (D1) into Long right decorative beam 1 /
(Short right decorative beam 1) A1 / (C1); tighten with Hex bolt (CC) & Large flat washer (BB). Repeat on all sides.
Fig.2
A ttach assembled beams to another respectively and tighten all with Hex bolt (AA) & Large flat washer (BB).
Fig.3
A ttach the middle beam connector (F1) on the middle of decorative beams with Bolt (CC) & Large flat washer
(BB). Repeat on all sides.
8 PCS
40 PCS
32 PCS
60 PCS
32 PCS
2 PCS
Fig.5
A ttach Short bar (H1) / Long bar (G1) to Long right decorative beam 1 &
Long left decorative beam 2 (B1) / Short right decorative beam 1 (C1) & Short
left decorative beam 2 (D1) by using Hex bolt (CC) & Large flat washer (BB).

Publicité

Table des Matières
loading

Produits Connexes pour UBERHAUS DESIGN Sonoma

Ce manuel est également adapté pour:

38115059

Table des Matières