Bosch KDN Série Mode D'emploi page 20

en
Fault
Controls have reduced
luminosity.
Displays do not illuminate.
Warning signal sounds.
The alarm button is lit.
Fig. "/5
The temperature in
the freezer compartment is
too warm.
20
Possible cause
When the appliance is not
used for some time,
the display on the fascia
switches to energy saving
mode.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Fault – the freezer
compartment is too warm!
Appliance is open.
Ventilation openings have
been covered.
Too much food was placed in
the freezer compartment at
once.
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
Remedial action
As soon as the appliance is again used, e.g.
the door is opened, the display switches back
to normal illumination.
Connect mains plug. Check whether the power
is on, check the fuses.
To switch off the warning signal, press
the alarm button 5.
Close the appliance.
Ensure that there is adequate ventilation.
Do not exceed max. freezing capacity.
When the fault has been eliminated, the alarm
button goes out shortly afterwards.
Do not open the appliance unnecessarily.
Remove obstacles.
Do not exceed max. freezing capacity.