Cd Changer; Listening To A Cd; Locating A Specific Track - Sony CDX-454XRF Mode D'emploi

CD Changer

Listening to a CD

1
Turn on the FM tuner of your car audio.
2
Tune in the selected transmitting
frequency* with the FM tuner of your car
audio.
* The frequency of the unit is set to 88.3 MHz
at the factory.
You can change the frequency. (See
"Changing the transmitting frequency" on
page 5.)
3
Press u.
CD playback starts.
4
Adjust the volume with the volume
control on your car audio.
All the tracks play from the beginning.
Stopping CD play
Press (OFF).
Notes
• When CD playback stops, you may hear some
noise from the speakers. To prevent this from
happening, turn the volume down before
stopping CD playback.
• If you turn off the ignition switch of your car
without stopping CD playback, it will
automatically resume CD playback from where it
was stopped when you turn on the ignition
switch again.

Locating a specific track

— Automatic Music Sensor (AMS)
During CD playback, push down either
side of (AMS) once for each track you
wish to skip.
To locate
previous
tracks
6
Locating a specific point in a track
— Manual Search
During CD playback, push down and
hold either side of (AMS). Release the
control when you have found the
desired point.
To search
backward
Locating a specific disc
— Disc Select
During CD playback, press (DISC+) or
(DISC-) once for each disc you wish to
skip.
Listening to the radio or a tape
Be sure to stop CD playback before you start
listening to the radio or a tape.
Note
Be sure to stop CD playback, otherwise there may
be some interference with radio reception.
To locate
succeeding
tracks
To locate succeeding discs
To locate previous discs
To search
forward