Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION GUIDE
C/ Lost IP address :
If you cannot remember the SPL20 IP address, use the following procedure:
[ Have something to write the IP address. Plug and disconnect two times the sensor. This will
display the IP address using GPO1 and GPO2 leds. GPO1 led gives IP address and GPO2
shows the points between the numbers.
Example :
"1"
: GPO1 led blinks once, then blank.
"2"
: GPO1 led blinks twice, then blank.
"9"
: GPO1 led blinks nine times, then blank.
"0"
: GPO1 led blinks for a while, then blank.
: GPO2 led blinks once, then blank.
"."
For instance : IPAdress : 192.168.0.96
GPO1 led blinks once, then
GPO1 led blinks nine times
then GPO1 led blinks twice
GPO1 led blinks once, then
GPO1 led blinks six times
then GPO1 led blinks eight
times.
GPO1 led blinks for a while
GPO1 led blinks nine times,
then GPO1 led blinks six times
ENGLISH
GPO2 led blinks once
GPO2 led blinks once
GPO2 led blinks once
1 9 2 . 1 6 8 . 0 . 9 6
,
,
30
GPO1
GPO2
AMIX - SPL20
Next
Publicité
Table des Matières
