Display Functions - Cicli Esperia E210U Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.

Display functions

• To turn the device on, press and hold the "M" button for 1 second.
• To turn it off, press and hold the "M" button for 2 seconds.
• The remaining battery level is displayed on the left hand side of the display.
• The right hand side of the display indicates the assistance levels (PAS) of 9
selectable speeds with the "+" or "-"
buttons.
• To access information relating to speed and kilometres, press and hold the "M" and
"+" buttons for 2 seconds, to select the next entry repeat the combination. To reset
the TRIP entry, press and hold the "M" and "-" buttons for 2 seconds.
• To start the Walk-Assist mode (6 km/h), press and hold the "-" button.
NOTE: The Walk-Assist function can only be activated when PAS=0.
• Should the bicycle not be used for 5 minutes, the display will turn off automatically.
• Should the bicycle not be used for 5 minutes, the display will turn off automatically.
• To activate the Cruise Control System, identifi ed by the
symbol, briefl y press
the "M" button on reaching the desired speed to maintain with motor assistance.
• To deactivate this function, press the "M" button again.
WARNING: If the odometer shows a current speed of 0 km/h even when the bicycle
is in motion, check that the magnet on the rear wheel has not moved away from the
speed sensor. If the problem persists, a warning will show on the display; to return to
normal e-bike operation, move the magnet as close as possible to the speed sensor.
Turn the display on the handlebars off and then on again.
85

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

E211d

Table des Matières