Asist AE1K105DN Mode D'emploi page 41

ADDITIONAL SAFETY INSTRUCTIONS
Please read these safety instructions before use and
keep them in a safe place.
! - This symbol indicates the risk of injury or damage
to the device.
! Failure to follow the instructions in this manual may
result in injury.
! The electro-pneumatic hammer drill complies with
the applicable technical regulations and standards.
Always use the auxiliary handle (3) when working with
these tools.
! When using el. Always wear safety goggles accord-
ing to accessories. standards or other suitable eye
protection /e.g. the protective shield/. Wear a dust
mask or respirator in areas where dust is generated.
Goggles or other eye protection will bounce off frag-
ments of material that could endanger your face or
eyes. Blowing dust or gases released by drilled mate-
rial (eg asbestos-insulated pipes, radon) can cause
breathing diffi culties.
- Use protective equipment against noise, dust and
vibration !!!
SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION (A)
An electropneumatic hammer drill can be used to drill
holes and make grooves in building materials such as
bricks and concrete.
This tool can drill large holes at high speeds using
low power. Read this manual carefully and keep it in a
safe place for future reference.
1. Clamping sleeve
2. Power switch
3. Additional handle
4. Gear lubrication hole cover
5. Hammer / chisel / drill switch
6. -
7. Accessories
8. Gear lubricant
Pictograms
Pictograms on the product packaging:
a) Power supply values
b) Power consumption
c) Idle speed
d) Maximum borehole diameter
e) Impact frequency
USE AND OPERATION
ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under high
loads.
Any additional requirements must be the subject of
an agreement between the manufacturer and the
customer.
! It is necessary to observe work breaks when wor-
king with tools.
The time interval between work and break depends
on the complexity of the work, the load of the device
and the hardness of the material. In general, the
harder the material, the shorter the work cycles and
the longer the work breaks.
! Failure to observe work breaks can lead to irrepa-
rable damage to the tool.
! Before use, always make sure that there is enough
lubricant in the gear unit.
Before starting work, always check the work area for
hidden electrical cables, gas and water pipes, use a
metal detector, for example.
Always use the correct supply voltage!
The power supply specifi cation on the identifi cation
plate must correspond to the supply voltage.
The tool must always be fi rmly seated.
The power cord must be routed from the back of the
tool and far enough away from the tool.
When working with this tool, use the auxiliary handle
(3).
Always hold this tool fi rmly and stand in a stable
position.
If the force exerted on the tool is too great, it will have
a negative effect on the drilling effi ciency and the life
of the electropneumatic hammer drill and tool.
If the drill bit is blunt, it is necessary to sharpen it in
time or replace it with a new drill bit. Otherwise, the
drilling effi ciency will be impaired and the tool parts
may be damaged.
This tool is equipped with a safety clutch. If the drill is
jammed or blocked, the safety clutch prevents the tool
from twisting and dropping during operation.
Switching the drill hammer on and off (B)
Switching on: Press the switch (2) and hold it in the
pressed position.
Switching off: Release the switch (2).
Insert tool (C)
41