Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle; Option Selections - Estate TUD6710 Guide D'utilisation Et D'entretien

Normal
Use this cycle for loads with normal amounts of food soil. (The
energy-usage label is based on this cycle.)
Use covered detergent dispenser section.
Wash Main Rinse or Final
Wash Purge Rinse
●
Purge
Light
Use this cycle for prerinsed or lightly soiled loads.
Use covered detergent dispenser section.
Wash Main Rinse or Final
Wash Purge Rinse
● ●
Purge
Rinse & Hold
Use this rinse cycle for rinsing dishes, glasses, and silverware
that will not be washed right away.
Do not use detergent with this cycle.
Wash Main Rinse or
Wash Purge
●
Rinse

Canceling a Cycle

1. Press CANCEL/DRAIN. The Cancel/Drain light glows.
2. The dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely. The light turns off after
2 minutes. The door must be closed for the dishwasher to
drain.
To stop the drain
You can press CANCEL/DRAIN again to stop the drain. Be sure
to drain the dishwasher before starting a new cycle.
10
Dry Approximate
Time
● ●
1.5 hrs*
Dry Approximate Water Usage
Time
●
1.5 hrs*
cycled
Final Dry Time (min)
Rinse
10

Changing a Cycle or Setting

You can change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
2. Select a new cycle and/or options.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
4. Close the door firmly until it latches. Press START/RESUME.
The dishwasher starts a new cycle.
Water
Usage
(gal/L)

Adding Items During a Cycle

4.6/17.4
You can add an item anytime before the main wash starts, or the
cycle control knob reaches Normal Wash.
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches. Press START/RESUME.
The dishwasher resumes the cycle.
(gal/L)
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off.
4.8/18.2
Select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
anytime before drying begins.
After a wash cycle, the dishwasher remembers the options used
and uses the same options in the next wash cycle, unless you
select new options.
Hi-Temp Wash
Select this option to heat the water to 140°F (60°C) in the main
wash. This option adds heat and wash time. Heating the water
helps improve washing results.
NOTE: The Pots & Pans cycle automatically uses this option. Hi-
Water
Usage Temp Wash is an option with the Heavy and Normal wash cycles.
(gal/L)
This option does not work with the Light wash cycle.
2.2/8.3
Heated Dry
The Heated Dry option in combination with rinse aid will give you
excellent drying results. The energy to use Heated Dry costs
pennies per cycle. Heated Dry is on when the light is lit on the
Heated Dry button. Be sure to load plastic items in the upper rack
to avoid damage. You may turn off the Heated Dry option by
pressing HEATED DRY so that the light goes off. However, you
will have items in your dish load that will not be dry at the end of
the cycle.
NOTE: The Heated Dry option is used in all cycles except Quick
Rinse.

Option Selections