Cycle Selection Charts; Canceling A Cycle - Estate TUD6900 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Use cycles or options that add extra heat to the wash or rinse
portion of the cycle only when needed.
Run your dishwasher with full loads. Run a rinse cycle after
meals until the dishwasher is full.
If your home is equipped with a water softener, you may want
to avoid starting the dishwasher during the regeneration of
the softener, since this may contribute to poor wash
performance.

Cycle Selection Charts

Select the wash cycle and options desired and press START/
RESUME. The dishwasher starts filling once you press START/
RESUME, unless you select a delay wash. You can select an
option as the machine is filling.
After a wash cycle, the dishwasher remembers the options used
and uses the same options in the next wash cycle unless new
options are selected or Cancel/Drain is selected.
A " " shows what steps are in each cycle. Your model may have
some or all of the cycles shown.
Temperatures indicate where extra heat is added.
Water usage is shown in U.S. gallons/liters.
These models meet the ENERGY STAR
efficiency.
Cycle time includes dry time. An asterisk ( * ) by the cycle time
indicates the cycle time might be longer depending on the
temperature of the water entering the dishwasher. The cooler the
water, the longer the cycle time. If the water is already hot
enough, the cycle time will be as shown.
Pots & Pans
Use this cycle for hard-to-clean, heavily soiled pots, pans,
casseroles, and regular tableware.
Use both detergent dispenser sections.
Pre-
Rinse
Main
Rinse
Wash
Wash
140°F
140°F
(60°C)
(60°C)
Heavy Wash
Use this cycle for loads with heavy food soil.
Use both detergent dispenser sections.
Pre-
Rinse
Main
Rinse
Wash
Wash
10
®
guidelines for energy
Purge
Final
Dry
Time
Rinse
(min)
140°F
87*
(60°C)
Purge
Final
Dry
Time
Rinse
(min)
140°F
72*
(60°C)
Normal Wash
Use this cycle for loads with normal amounts of food soil. (The
energy-usage label is based on this cycle.)
Use covered detergent dispenser section.
Pre-
Rinse
Main
Wash
Wash
Light Wash
Use this cycle for prerinsed or lightly soiled loads.
Use covered detergent dispenser section.
Pre-
Rinse
Main
Wash
Wash
Rinse Only
Use this cycle for rinsing dishes, glasses, and silverware that will
not be washed right away.
Do not use detergent with this cycle.
Pre-
Rinse
Main
Wash
Wash
Water
Usage
(gal/L)
A small amount of water runs through the pump to remove soil
8.6/32.6
particles.
Anytime during a cycle, press CANCEL/DRAIN. Cancel/Drain
glows. The dishwasher pauses for about 5 seconds and starts a
2-minute drain (if needed). Let the dishwasher drain completely.
The light goes off when the dishwasher finishes the drain.
To stop the drain
You can press CANCEL/DRAIN again to stop the drain
Water
immediately. Remember to drain the dishwasher before starting a
Usage
new cycle.
(gal/L)
NOTE: A small amount of water remains in the dishwasher. This
6.9/26.1
is normal.
To clear the indicators
Press CANCEL/DRAIN before starting the dishwasher to clear all
options and cycles.
Rinse
Purge
Final
Dry
Rinse
140°F
(60°C)
Rinse
Purge
Final
Dry
Rinse
140°F
(60°C)
Rinse
Purge
Final
Dry
Rinse

Canceling a Cycle

Time
Water
(min)
Usage
(gal/L)
61*
4.8/18.0
Time
Water
(min)
Usage
(gal/L)
58*
4.8/18.0
Time
Water
(min)
Usage
(gal/L)
10
2.2/10.0

Publicité

Table des Matières

Dépannage

loading

Table des Matières