Using The Device - Atlantic Ulysse Notice D'utilisation Et D'installation

1) Description of the control box
C
B
A
2) Heating mode
This mode enables you to maintain the desired temperature in the room.
a) Set the switch A to Heating.
b) Set wheel B, the heating indicator C lights up if the ambient temperature is lower than the tem-
perature desired.
c) Wait a few hours for the temperature to stabilise.
d) If the setting suits you (use a thermometer to check, if need be), mark the position once and for all.
If you do not like the setting, readjust it and return to point c.
3) Anti-Frost mode
This mode enables you to maintain the temperature in the room at around 7°C during prolonged
absences from home (generally more than 24 hours).
a) Leave the switch A set to Heating.
b) Set wheel B to .
4) Turbo Max 2h mode
This mode enables you to increase the room's temperature rapidly and to heat your towels.
a) Set the switch A to Turbo Max 2h.
b) Set wheel D to adjust the desired temperature.
If you forget about it, the Turbo function will be cut off automatically after 2 hours. The device then
goes to Stop mode. In this case, remember to reset the switch A to the desired mode (otherwise the
device will stay in Stop mode).
5) Using the pilot wire
This device is fitted with a thermostat capable of receiving instructions via its pilot wire. It recogni-
ses the following instructions:
- COMFORT :The temperature set by wheel B.
- COMFORT -1 :The temperature set by wheel B: -1°C.
- COMFORT -2 :The temperature set by wheel B: -2°C.
- ECO :Comfort temperature reduced by approx. 3 to 4°C.
- ANTI-FROST :Ambient temperature maintained at around 7°C.
- STOP :The heating stops immediately (used for power cuts).
U
SING THE DEVICE
A
Mode switch wheel
D
B
Heating wheel
C
Heating indicator
D
Turbo Max 2h wheel
E
E
Programming mode indicator
12
GB