Important Safety Instructions - Dolmar AB-1816 Manuel D'instructions

• AB-1816 requires less pedal power than a normal
bicycle to move. However, until the cyclist gets used to
lighter pedaling, he or she may pedal too powerfully,
causing faster speeds than a normal bicycle, which
may lead to accidents, such as a fall or crash.
• Do not ride the bicycle across extremely bumpy
surfaces (pavement curbstones, drainage runs, etc.).
• When bringing the bicycle to a halt, apply both front
and rear brakes.
• Do not ride the bicycle when there is a problem with it.
• Do not dismantle or lubricate the parts comprising the
power assist system.
• Do not remodel the bicycle by yourself.
• Only use genuine parts as accessories or
replacements.
• After removing/replacing wheel(s) or adjusting the
saddle, always check that relevant bolts have been
tightened before riding the bicycle.
• Never ride the bicycle with the saddle or handlebar
higher than the limit line.
• Do not lubricate brake, tires or rims in damping areas.
1. Check before use.
For the safety use, please check the following before
using it.
a. Check if the tires and screws work well.
b. Brake system: When the brake level reaches its 1/2
range, the brakes have to stop the bicycle completely.
c. Power system: Check if the battery is fixed well, and
the power is full for use.
2. Attention:
a. Please decelerate when turning and going downhills.
Article 1.
To the customer
a. Thanks for selecting our AB-1816, and we wish it
could bring you an excellent riding experience.
b. Please read the manual carefully before using AB-
1816. If any questions, please contact one of our
agent without hesitation.
Article 2.
Introduction of AB-1816
1. To secure your safety, please check the product
before use.
a. Does the brake system work well?
b. Does the E-system work well? (Ref: 3.3)
c. Are the handlebar and saddle in position and locked
well?
d. Is the tire pressure normal?
e. Are the Folding handle and pedals locked well?
2. AB-1816
a. This product is designed for the customer's easy
operation.
b. AB-1816 could protect the battery under a over-
current or low voltage situation.
c. The front brake and band brake provide safe
functions.
d. Within one year, the regular usage range could
comply with the EN15194 requirement.
6
3. Operation
3.1 How to adjust your position on the bicycle
1. Measure your height. (Fig. 1)
2. Refer to the bicycle's settings table.
S (cm)
155 – 159
160 – 164
165 – 169
170 – 174
175 – 179
180 – 184
185 – 190
3. Adjust your bicycle. (Fig. 2 – 3)
Warning
• Do not ride the bicycle when the safety lines on the
seat or handles are visible.
Adjusting the seat
Minimum seat height is the height determined when the
position of the seat is lowered and the clamp is locked.
Practical Information
Depending on the terrain you are travelling on, the seat
height can be modified:
- On a flat ground or when climbing, the seat should be
in a high position for the greater efficiency.
- When travelling downhill, the seat should be slightly
lowered to improve bicycle control and to make it
easier to go over or circumvent obstacles.
3.2 Introduction of battery:
Use and care for AB-1816
• Remove the battery from AB-1816 when not in use.
• Recharge only with the charger specified by the
manufacturer. A charger that is suitable for only one
type of battery pack may create a risk of fire when used
with another battery pack.
• Use AB-1816 only with specifically designated battery
packs. Use of any other battery packs may create a
risk of injury and fire.
• When the battery pack is not in use, keep it away from
metal objects, like paper clips, coins, keys, nails,
screws or other small metal objects, which can make a
conductive connection from one terminal to another.
Shorting both the battery under abusive conditions,
terminals may cause burns or a fire.
• As liquid may leak from the battery, avoid contact. If
you touch it accidentally, flush with water. If the liquid
contacts with eyes, seek medical help. Liquid leaked
from the battery may cause irritation or burns.
IMPORTANT SAFETY
INSTRUCTIONS
For battery cartridge
• Before using battery cartridge, read all instructions and
cautionary markings on the (1) battery charger, (2)
battery, and (3) product the battery is used for.
• Do not disassemble the battery cartridge.
Hs (cm) H (cm)
55.5
58
60
62.5 +12
64.5
67
69.5
(Fig. 2) (Fig. 3)