Dometic Waeco PerfectView VS400 Instructions De Montage Et De Service page 23

VS400
If you disconnect the negative terminal of the battery, all data stored in the volatile mem-
ories will be lost.
 The following data must be set again, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following installation instructions:
CAUTION!
!
 Secure the parts installed in the vehicle in such a way that they cannot be-
come loose under any circumstances (sudden braking, accidents) and cause
injuries to the occupants of the vehicle.
 Secure any parts of the system covered by the bodywork in such a manner
that they cannot be come loose or damage other parts and cables or impair
vehicle functions (steering, pedals, etc).
 Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be
performed by qualified specialists.
NOTICE!
A
 To prevent damage when drilling, make sure there is sufficient space on the
other side for the drill head to come out.
 Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
NOTICE!
A
 When testing the voltage in electrical cables, only use a diode test lamp or a
voltmeter.
Test lamps with an illuminant take up voltages which are too high and which
can damage the vehicle's electronic system.
 When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders or insulating
tape, for example to existing cables.
EN
Safety and installation instructions
23