Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User Manual
01
02
A
Detail A
03
04
IMPORT ANT : Inst all using a fine-tipped
screwdriver.
Remove the aluminum front covers with a fine-
tippedscrewdriver , prying as shown in the figure.
After the covers have been removed, drill two
holes, one at each end, as shown in the figure.
Make the hole in the slot as shown in detail
(A).
Depending on the wall material, screw anchors
may need to be installed. In the case of wood,
only wood screws will be required.
Use a screwdriver to secure the light assembly
to the wall as shown in the figure.
Press the front covers into place.
Connect the power cable to the GST-18
connection.
The product is installed
ES EN
Publicité
Table des Matières
