Setting And Use Of Apparate; Warranty Conditions - Lofrans THETIS 1002 Manuel D'installation

www.lofrans.com
The wires must have a minimum cross section size of 1.5 mm². Install a 5 A (ampere) fast safety fuse on the positive(+) wire of the battery.
Do not use the voltage generated by the engine battery set to provide power.
If posible mount the connector in a dry place so the rear part of the plug must be protected from contact with water or moisture.
Secure the hand held control in place with the cradle provided, tightening the two screws using a cross screwdriver.

5 SETTING AND USE OF APPARATE

DON'T OPEN REMOTE CONTROL OR PLUG TO WARRANTY WATER TIGHT PROTECTION!
- Connect the plug into the socket and turn its locking ring clockwise until it stops to switch on the remote control.
- Switch on electrical power. Be sure that the controls operate in the correct direction; if not swap over the
wires at the socket.
- Push UP or DOWN command to use windlass.
- Release the button to stop.
DON'T PUSH THE BUTTON SIMULTANEOUSLY!

6 WARRANTY CONDITIONS

We guarantee our products from manufacturing defects for 2 years from the purchase date (purchase ticket or any other purchase
proof will be requested). Guarantee does not include damages and breakage during the transport, damages and breakage due to faulty
installation or improper use. Warranty is no longer valid when repairs or servicing have been made by unauthorized people or made with
spare parts which are not original. Warranty does not include the complete replacement of the goods and refers exclusively to the replace
of faulty pieces and necessary labour. It does not include transfer or transport expenses. The Customer will not ask for expenses refund.
UK
UP and DOWN
5