Safety Precautions - HQ TORCH-L-WLAMP Mode D'emploi

Charging the Work Light
1. Plug in the home or car adapter to the charger socket.
2. Plug the charging adapter to its power source and the indicator LED will turn on (red).
3. Charge the work light until the red indicator LED turns to green.
4. When the torch is fully charged, remove the charging adapter from its power source.
Advice: Also charge the work light regularly (at least every 6 months) when not in use.
Use as a Hand Light
- Switch the light on or off with the power switch [Fig. no. 4].
Advice: Avoid using the light with a completely discharged battery and do not expose the battery
to any permanent total discharge. This could cause damage to the battery.
- The light may be hung onto the rotatable hook.
Important: Do not attach the hook to hot objects. The hook may bend due to the weight of the
work light.

Safety precautions:

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
not expose the product to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or
damage caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Keep this manual for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.
To reduce risk of electric shock, this product should ONLY be opened
by an authorized technician when service is required. Disconnect the
product from mains and other equipment if a problem should occur. Do
3