HC Cargo 171850 Manuel D'installation page 8

FLASHING TD & ALLEYs
Activate Flashing Take Downs & Alleys by applying +VDC to RED-BLK wire.
To scroll to a different configuration, tap +VDC to YELLOW wire:
• Take Downs and Alleys flashing
• Alleys only flashing
• Take Downs +VDC toonly flashing
NOTE: Flashing Take Downs & Alleys have priority over the steady burn functions.
CRUISE MODE
Activate Cruise mode by applying +VDC to GRAY wire. All corner lightheads will be activated in low power
steady burn. To activate more lightheads tap +VDC to PURPLE wire while in CRUISE mode; the lightheads
immediately next to the corner lightheads will be activated.
TRAFFIC ARROWS
During Mode 1, Mode 2, or Cruise mode,
activate Traffic Arrow functions by applying +VDC to:
• ORANGE wire for Left Arrow.
• BLUE wire for Right Arrow.
• ORANGE & BLUE wires for Center Out.
To configure the Traffic Arrow flash patterns,
tap +VDC to YELLOW wire:
• Once for next pattern
(refer to Traffic Arrow Patterns chart).
• Quickly 3 times within second for reset to FP#0.
NOTE: If the bar is equipped with the Dual Color Traffic Arrow option, the rear lightheads will automatically
switch to Amber when the Traffic Arrow function is activated; and will automatically switch back when the Traf-
fic Arrow function is deactivated.
OTHERS
To activate other functions, apply +VDC to:
• BROWN-BLK wire for Take Down Lights
• ORANGE-BLK wire for Right-Side Alley Light
• BLUE-BLK wire for Left-Side Alley Light
• YELLOW-BLK wire for Front cutoff
• GREEN-BLK wire for Rear cutoff
• GREEN wire for Low Power
171850 - 171853
171909 - 171914
FP# Traffic arrow patterne
0
Sweep Single
1
Sweep Double
2
Sweep Triple
3
Sweep Single End-Double
4
Solid
5
Solid End-Double
6
Solid Chaser
7
Solid Fade
8
Blink Double
9
Blink Triple
10
Blink Solid
8
Vedpak 177_Version 2_061013