Candy CITT642SSC Mode D'emploi page 13

Or
a. If you don't select a heat zone within 1 minute, the ceramic hob will
automatically switch off. You will need to start again at step 1.
b. You can modify the heat setting at any time during cooking.
c. If slide along the "—", power will vary from stage 2 to stage 8.
Press "-", power will decrease by one stage each time till stage 0.
Press "+", power will increase by one stage each time till stage 9.
If the display flashes
setting
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minutes if no suitable pan is placed
on it.
When you have finished cooking
1. Touching the heating zone selection control that you wish to
switch off.
2. Turn the cooking zone off by touching the "-"and scrolling down to "0".
Or slide along the "—" to the left point, and then touch the "-".
Or touch the left point of "—", and then touching the "-".
Or
alternately with the heat
EN-12