Perel EFL44 Mode D'emploi page 5

6. Batteries
1. Unscrew the nightlight from the flashlight.
2. Take out the battery holder from the flashlight.
3.
Install the batteries in the holder according to the correct polarity.
4. Insert the battery-loaded holder back in the flashlight and close.
Warning: Do not puncture batteries or throw them in
fire as they may explode. Do not attempt to recharge
non-rechargeable batteries (alkaline). Dispose of
batteries in accordance with local regulations. Keep
batteries away from children.
7. Operation
7.1 Charging
Inductive charging of the batteries could not be easier:
1.
Make sure the flashlight is loaded with rechargeable batteries
only.
2.
Insert the charger into the mains.
3. Insert the flashlight into the charger. Charging will automatically
stop.
7.2 Torch
1. Take the flashlight out of the charger.
2.
Press the on-off button to switch on the flashlight.
3. Select the brightness (100 % > 50 % > 20 %) with the mode
button.
4. Switch off the flashlight after use. Install the flashlight in the
charger if necessary.
7.3 Nightlight
1. Install the flashlight into the charger.
2. Switch on the flashlight. The nightlight will switch on with an
ambient light under 10 lux.
3. Switch off after use.
7.4 Emergency Light
1.
Install the flashlight into the charger.
2. The flashlight will automatically switch on in case of a power outage.
3.
Switch off after use.
V. 01 – 11/08/2015
EFL44
5 ©Velleman nv