Dmx 512 Connexions - Nicols PAR LED 1418 Z IP Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4- DMX 512 CONNEXIONS

If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin adapter-cable.
At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm 1/4W resistor between pin
2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last unit
.
Connect the unit together in a `daisy chain` by XLR plug from the output of the unit to the input of the next unit.
The cable can not branched or split to a `Y` cable. DMX 512 is a very high-speed signal. Inadequate or damaged
cables, soldered joints or corroded connectors can easily distort the signal and shut down the system.
The DMX output and input connectors are pass-through to maintain the DMX circuit, when one of the units' power is
disconnected.
Each lighting unit needs to have an address set to receive the data sent by the controller. The address number is
between 0-511 (usually 0 & 1 are equal to 1).
The end of the DMX 512 system should be terminated to reduce signal errors.
3 pin XLR connectors are more popular than 5 pin XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin 4/Pin 5: Not used.

Publicité

Table des Matières
loading

Table des Matières