Clearing The Built-In Memory; Scrolling The Sheet; Vertical/Horizontal Position Setting - Plus M-5 Manuel De L'utilisateur

Clearing the built-in Memory

Use this procedure to clear all the image files in the built-in memory.
Note: The procedure described below clears all the image files in the built-in memory. Be sure to store important
images on a CF memory card or computer before the operation.
Press the CLEAR button and hold it in for more 3 seconds.
Once the CLEAR button has been held in for more 3 seconds, the MEMORY
indicator blinks slowly and file clearing starts.
When an error with the memory clearing has occurred and the indicator changes
to the error blinking pattern, start over.

Scrolling the Sheet

Press the FEED/STOP button when you have used up the surface of the sheet and want to move to another surface
to draw, or when you adjust the sheet position from which scanning is to start. The sheet can also be scrolled in the
standby mode.
Scrolling the sheet automatically
Press the FEED/STOP button.
The sheet scrolls one sheet's worth to the left (or upwards).
• To stop in the middle, press the FEED/STOP button again.
Scrolling the sheet manually
The sheet can be scrolled even if the copyboard's power is turned off.
Move the sheet using your palm. The sheet moves either right or left
(up or down * 1 ). Place your palm at the center in the vertical (or hori-
zontal * 1 ) direction and move the sheet gently.
1
(* When the copyboard is installed in the vertical position.)
Note: Moving the sheet too abruptly may damage the copyboard's
drive mechanism.

Vertical/Horizontal Position Setting

The direction in which images are stored differs according to whether the copyboard is installed in the vertical or
horizontal position. (The position setting is set to horizontal upon shipment from the factory.)
1. Prepare a tool to press the button in the pin hole, for example a paper
clip that has been bent out, etc.
2. Check that the POWER indicator is lit. If it is off, press the POWER but-
ton.
3. Stick the paper clip, etc., into the POSITION hole on the control panel
and press.
The MEMORY indicator blinks slowly for 5 seconds, and the position
setting is switched to vertical.
To switch back to horizontal, press the POSITION button again.
The POWER indicator blinks slowly for 5 seconds, and the position setting is
switched back to horizontal.
The setting switches between vertical and horizontal each time the button in
the pin hole is pressed.
The diagrams used in the explanations below show the
copyboard installed in the horizontal position.
E-12