Operation - Tetra Tetronic LED Connect Complete Set 580 Mode D'emploi

UK

OPERATION

Operating and display components
b
a
TLL0012
Installing the app
The LED luminaire is controlled by smartphone or tablet using
the "Tetra Aquatics" app, which you can get free of charge from
the App Store (iOS) or Play Store (Android).
Launching the app for the first time
When you launch the "Tetra Aquatics" app for the first time, you
will be asked to register with Tetra (if you have not already done
so). You will need to provide a user name and password. You can
then use these details to log in.
Pairing the app with the LED luminaire
The pairing procedure is described below. Further relevant
information, particularly with regard to app components, can be
found in the "App screens" section.
Procedure:
1. If the status LED on the control box is not flashing blue (→
Operating and display components), you must first set the
control box to pairing mode. To achieve this, press the reset
button next to the status LED for approx. 5 seconds using
e.g. a paper clip that has been bent open. The LED should be
flashing blue.
2. Launch the "Tetra Aquatics" app, log in with your user name
and password, and select "My Aquarium".
3. Add a new aquarium or select an existing one. Accept the
prompt asking whether the app can access your location.
4. Click on the Wi-Fi symbol on the "My Aquarium" screen.
12
Reset button (a): to be pressed using e.g. a paper clip
that has been bent open.
Press for 5 seconds: activates pairing mode – the
luminaire waits to be connected to a smartphone/
tablet. The LED (b) flashes blue.
Press for 10 seconds: resets to factory settings.
Status LED (b)
Flashing blue: Control box waiting to be connected
to a smartphone/tablet (pairing mode).
Flashing green: Control box initialising or
transmitting/receiving commands.
Continuous green light: Connected to the app.
Tetronic LED Connect Complete Set