Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
4.
Ignition
Open the cylinder tap and turn on slowly the tap of the torch. Bring a
flame just under the burner.
5.
Use
Adjust the flame intensity by opening or closing the tap. In case the
device is provided with an opening lever, reduce the flame to its
minimum by turning the knob and operate the lever to get the
suitable flame intensity. The lever's release involves an automatic
and immediate return to the minimum flame setup.
6.
Maintenance
The use of dirty gas coming from the cylinder bottom may cause a
partial blocking of the jet. To clean it, remove the burner and the
injector, and wash carefully with gasoline or a similar product, or
with thin wire. Do not widen the injector.
7.

Important

Do not pull the rubber hose (EN ISO 3821) if connected to the gas
cylinder. Verify the condition of the hose before use. Replace it if
damaged, cut or overheated. The production date is printed on the
hose.
8.
Interchangeable Burners
In case the instrument is supplied with interchangeable burners or
you need additional ones, remove the installed burner from the
device together with the hexagonal adapter and assemble the new
one. Pay attention to the fit of the aluminium washer.
The torch is supplied with 40 mm flat burners and 20 mm welding
and soldering burners. They must be tightened up directly to the
17 mm burner installed in the torch.
V. 01 – 29/11/2016
WELD-xxx/105/110C
3
©Velleman nv

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Weld-105Weld-110c

Table des Matières