Dismantling - Crivit 290255 Notice D'utilisation

Step 3
Push the four corner poles (3) into
the universal joints. Ensure that the
locking buttons (3a) fit into the holes
both visibly and with an audible
click.
Caution! Danger of getting
stuck.
Unfold the upper segments of the
corner poles (Fig. C).
Step 4
Put the shelter roof (1) over the
frame. Fasten the shelter roof with
the help of the pre-fitted hook-and-
loop fasteners (1a) to the corner
poles (Fig. D).
Step 5
Unfold the lower segments of the
corner poles. Fit one supporting
foot (5) each into them. Fasten the
pre-fitted eyelets (1b) into the hooks
(5a) provided for the purpose on
the supporting feet (Fig. E).
Step 6
Fit the segments of the roof frame (4)
together. Push the rods in succession
diagonally onto the metal pins (2b)
of the universal joint.
Fasten the shelter roof by means of
the pre-fitted hook-and-loop faste-
ners (1c) to the rods. Fix both the
rods with the hook-and-loop fastener
(1d) (Fig. F).
10 GB/IE/NI
Step 7
Thread a tent peg (6) through the
loop (1e). Anchor every supporting
foot with the help of the tent pegs.
To that end, use the openings in the
supporting feet (Fig. G).
Attention! Check for firm
fitting of the tent pegs.
Step 8
Knot one guy rope (7) each with
every loop (1f) at the outermost
corners of the shelter. Stretch out the
ropes and fasten each of the ends to
a tent peg. The length of the guy ro-
pes can be adjusted with a tightener
(7a) Fig. G).
Attention! Here, too, pay
attention to firm fitting of the
guy ropes.

Dismantling

Step 1
Loosen the tent pegs of the guy
ropes and supporting feet.
Step 2
Loosen the hook-and-loop fasteners
at the roof frame. Remove the two
rods from the metal pins.
Step 3
Unhook the shelter roof at the
supporting feet. Fold up the lower
segment of the corner poles and
remove the shelter roof.