Use; Cleaning - Profi Cook PC-WKS 1192 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Electrical Connection
1. Check whether the electrical voltage that you intend to
use is the same as that of the appliance. Details are to
be found on the label on the base.
2. Only connect the appliance to a properly installed safety
socket.
Switching the Appliance On / Off
• Switching on:
Press the toggle switch downwards. The indicator light in
the switch lights up.
• Switching off:
Press the toggle switch upwards. The indicator light in
the switch goes off.
Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives
or ingredients.

Use

NOTE:
• Ensure that the filter is correctly inserted in the spout
opening.
• Always use fresh water.
1. Place the appliance on a flat surface.
2. Also hold the kettle by the handle and open the lid.
3. Then fill in the water (max. 1.7 Litre). You can read the
filling level on the water level indicator of the kettle.
WARNING:
• Always turn the appliance off before cleaning it and remove the
mains plug. Wait until the appliance has cooled down.
• Never immerse the appliance or the base in water or other liq-
uids. Otherwise this might result in an electric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Rinse the water container out with clean water. Then dry
it off with a cloth.
• Clean the housing after use with a slightly damp cloth.
PC-WKS1192_IM
4. Close the appliance with the lid. It must audibly click into
place.
5. Place the appliance flush onto the base.
6. Switch on the appliance. The control lamp in the switch
will light up.
NOTE:
The water temperature can be seen on the display.
Pausing / Terminating Operation
There are two options to interrupt the boiling process or to
terminate it:
1. The appliance will shut off automatically after the boiling
process. The indicator lamp will go out.
2. Press the switch upwards to interrupt the boiling process,
respectively to terminate it.
CAUTION:
Do not remove the appliance from the base without shut-
ting it off first. The contacts on the base are not suitable
for disconnecting the power supply.
WARNING: Danger of scalding!
• When pouring the water out, keep the lid closed.
• During operation the housing becomes hot. Do not
touch it and allow the appliance to cool down before
storing it away.
• Hot steam may escape when you open the appliance!
• Remove the plug from the socket.
• Emptying the water container.

Cleaning

Filter
A permanent filter is located at the spout opening. To clean
the filter, remove it from the kettle.
• Rinse the filter out under running water. Clean it with a
nylon brush if it is necessary.
• Re-insert the filter. To do so, use the guides on the inside
of the kettle. The filter must click audibly into place.
37
19.11.19

Publicité

Table des Matières
loading

Table des Matières