Table des Matières
Publicité
80
Bulb Replacement
1
Remove the screw securing the lamp assembly to the housing (set aside for reinstallation). Work the
lamp assembly out through the hole in the baffle.
2
There are two brass screws (one on each side) that secure the bulb to the lamp assembly. Use a
small standard screwdriver to loosen the screws.
NOTE: Do not loosen the screws that secure the wire to the ceramic lamp base.
Housing
(attached to the baffle).
3
Remove the bulb from the lamp base by pulling the bulb straight up from the base (do not twist).
4
Install the replacement bulb into the base. Secure the bulb by tightening the brass screws loosened
in step 3.
NOTE: DO NOT TOUCH THE BULB WITH YOUR FINGERS. Oils from your skin will shorten the
bulb's life.
Return the fireplace to its correct configuration.
Pièces de remplacement
Attention:
Utilisez seulement des pièces de remplacement de Travis Industries.
Avertissement: Ne pas utiliser le foyer avec la vitre retirée, craquée ou brisée. Le remplacement de la
vitre doit être fait par un technicien qualifié.
Contactez votre détaillant Travis Industries pour les pièces de remplacement
© Travis Industries
Entretien
Do not loosen these screws
(they hold the wires in place).
9/20/18-1384
Micro (1/8")
Standard Screwdriver
Lamp Assembly
DaVinci-Cat1
Publicité
Table des Matières
