Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User manual
3
Intended Use
Another use than described in chapter "Description and Function" is not per-
mitted. Neglegting and ignoring these regulations and safety instructions can
cause serious accidents, personal injury and material damage.
4
Commissioning
4.1
LAN cable tester
4.1.1
Changing the battery
1.
Open the battery compartment at the back side of master unit.
2.
Connect a new 9 V Block to the battery clamps + and -.
3.
Lay the 9 V Block into the battery compartment.
A 9 V Block is not included in delivery.
4.
Close the battery compartment.
4.1.2
Connecting
Connect a network cable with RJ11 or RJ45 plugs to Master and Remote unit.
4.1.3
Operating
1.
Switch the device on (ON).
The LAN cable tester checks the single wires now. Alternatively you can use
the slow test function.
2.
Therefor switch the device to „SLOW" (S).
3.
Check the network cable.
11
Situation 1:
Pin 2 is wired 1:1.
Cable ok
Situation 2:
Pin 2 is not connected.
Cable defective
Situation 3:
Pin 2 and 3 short-circuited.
Kabel defekt
Situation 4:
Pin 2 is wired to Pin 6.
Crossover cable or defective
Publicité
Table des Matières
