Troubleshooting Guide; Speci Cations - Peavey Escort 6000 Manuel D'utilisation

Problem
No sound
(LCD not lit)
No sound
(LCD lit)
No E ects
Files on USB memory device will not
play back
Loud howling or squeal
from speakers
Sound is distorted
No sound
(Bluetooth )
®
Escort

6000 Speci cations:

®
Output Power:
Frequency Response:
Overload Protection:
Distortion:
Signal/Noise Ratio:
AC Power:
Weight Assembled:
(stands included)
Dimensions:
Speakers:
Phantom Power:
Escort

6000 Troubleshooting Guide

®
Check
Is power switch on?
Is line cord connected to live power outlet?
Are MASTER and CHANNEL GAIN controls up?
Are the channel EFX controls turned up?
Is the master EFX MUTE enabled?
Is an e ect activated in menu?
If it goes away when the CHANNEL or MASTER LEVEL
controls are turned down, then it is acoustic feedback.
Is the CHANNEL GAIN at a very high setting?
300 watts RMS (per channel)
40 Hz to 20 kHz +/-3 dB
10 dB of DDT that limits the PA output to prevent clipping that can damage the speakers
™
Less than 0.2% THD @ Max power
88 dB mic input typical
115 V AC 60 Hz or
230 V AC 50/60 Hz
50 lbs. (22.67 kg)
14.5" H x 36.75" W x 15.5" D
(36.8 cm x 93.3 cm x 39.4 cm)
Woofer 10" (254 mm)
Piezoelectric Horn Tweeter
15VDC Available on all XLR Inputs
Correction
Turn power switch on
Connect power cord to live outlet
Adjust both MASTER and CHANNEL LEVEL
controls upward to desired level. Check
speaker connections. Turn mic switch on.
Check mic or sound source connection.
Make sure desired e ect is selected in
Master e ect menu. Check the master
EFX MUTE. If the LED is illuminated the
EFX MUTE is active. Press the EFX MUTE
button once to disable. Adjust channel
EFX control until audio e ect is heard.
Make sure once MEDIA SELECT knob is
See the list of supported audio formats
mentioned previously in this manual.
Reduce microphone gain. Reposition
microphone behind or farther from
speakers. Observe FLS light above
Graphic EQ and reduce level of
corresponding slider.
Reduce LEVEL controls accordingly.
Start with CHANNEL LEVEL then adjust
MASTER LEVEL accordingly to achieve
desired volume with no distortion.
Place the Bluetooth/USB switch in the
"Bluetooth" position.
Bluetooth enabled device must be "paired"
before music can be played through the
Escort 6000. Once the device is paired, the
Active LED will light continuously.