General Maintenance; Cleaning The Nozzle - Ryobi P28014 Manuel D'utilisation

WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken, or destroy plastic which may result
in serious personal injury.
CLEANING THE UNIT
See Figure 8.
WARNING:
Always store and dispose of chemicals properly. Disposal
of contaminated rinse water should be performed
according to local ordinances and bylaws.
Draining the tank:
If there is any liquid left in the tank after spraying, the tank
should be drained before cleaning. Do not store chemicals
in the tank.
 Remove the battery pack.
 Unscrew the tank from the sprayer.
 Drain the contents of the tank through the fill area.
WARNING:
Fluid may escape from the quick connect if the tank is
not fully drained. Be cautious, and wear the appropriate
protective equipment as specified on the chemicals
MAINTENANCE
 Review chemical SDS sheet how best to secure and store
Cleaning the sprayer:
 Fill the tank about one-third full with clean water. A small
 Reconnect the tank to the sprayer.
 Reinstall the battery pack. Spray until the tank has been
 Refill and repeat the procedure with clean water. It may
 Allow all pieces to completely dry, then reinstall the tank
 Wipe the outside of the sprayer with a clean, dry cloth.

CLEANING THE NOZZLE

See Figures 9 - 10.
To clean nozzle:
 Remove the battery pack.
 Unscrew and remove the nozzle and o-ring from the
 Remove nozzle cap.
 Soak nozzle and o-ring in warm, soapy water.
 If necessary, use a fine needle to free any foreign materials
 After soaking, reinstall nozzle cap, o-ring and nozzle.
 Run clean water through the unit for 1-2 minutes.
CLEANING THE FILTER
See Figure 11.
NOTE: If chemical has recently been sprayed, use gloves
for this procedure.
 Unscrew the tank from the quick connect.
 Lift tabs on the side of the filter cap.
 Remove the seals and filter screen.
 With a soft brush and soapy water, clean debris from the
 Reinstall seals and screen.
 Press the filter cap on until the tabs securely fit back in
10 — English
your chemical solution when not in use.
NOTE: Drain the contents back into the original container
or a suitable replacement container. For disposal, follow
instructions on the product's label and all local, state,
and federal regulations.
amount of mild household detergent may be added.
NOTE: Never use flammable chemicals or abrasive
cleaning agents to clean the tank.
emptied. Make sure to direct the spray toward an area
that will not be damaged by the spray solution.
be necessary to rinse the tank more than once, then drain
again as directed above.
cap.
NOTE: Store the sprayer in an upright position. DO NOT
store the sprayer on its side.
sprayer.
clogging or restricting the nozzle.
filter screen.
place.