RISCO Group RW132XWR Instructions D'installation page 5

4. Installation
The repeater should be mounted at a location that provides good reception range
with the panel. Mount the repeater between the devices and the control panel at
a minimum height of 1.5 m from the ground or 50 cm below a ceiling.
NOTE: Do not mount the repeater near large metal objects or close to radiating
electronic devices such as computers and monitors, which may reduce the
sensitivity.
Installing the Repeater
1. Open the cover by twisting a screwdriver in the slot on the bottom of the case
(see Figure 1).
2. Punch out holes for the mounting screws and for the entry of the power
wires and then mount the repeater on the wall (see Figure 2).
3. Remove the battery divider and then connect a power source of 10 to 16 volts
AC or DC to the AC/DC terminals (see Figure 2).
4. Close the cover (see Figure 3).
NOTE: If you intend to add a repeater/repeaters by RF, make sure to complete
the procedure in the "Adding a Repeater to the Panel" section (below) before
closing the cover.
5. Secure with cover screw (see Figure 4).
5