Operation Instructions - Nemaxx VKM0325LED Mode D'emploi Original

RADIO REMOTE CONTROL
NOTE:
● The battery is not included in the scope of delivery! Only use CR 2450 button cells!
● The risk of being interfered by remote communication or terminal unit during operating exists (e.g.
probably interfered by other remote devices using the same frequency).
CAUTION
● Operating the motor! By frequent use, motor overheat protection status will be automatically
started. In that case, pressing on the remote control cannot run the awning. Users need to wait
for about half an hour for any manipulation. Otherwise there is a risk of lasting damages for which
no guarantee can be made. This thermal protection function acts to ensure the long life of the
awning.
● Always store the remote control in a dry and safe place after use.
● The remote control receiver is better protected if it is installed in an interior space away from rain
and sunlight.
An indicator light is flashing when one of the buttons is pressed. When power off, you can use hand crank to
open or close the awning.
Press button
Up
▬
Stop
Down
Switch
UP
STOP
DOWN
LED
LIGHT
EN

OPERATION INSTRUCTIONS

Function
Retract / close the awning
Stop opening/closing process
Extract / open the awning
Turn on or turn off the LED light
P2
16
P2 P2
KEN002VKM
v1a • 17.04.2020