ARIETE Ghiro 8810 Mode D'emploi page 11

26. DO NOT INSERT PINS OR NEEDLES.
27. If the safety fuse blows, the appliance must be returned to the manufacturer or
its representative.
CONNECTION OR REMOVAL OF THE TEMPERATURE ADJUSTMENT
CONTROL (FIG. 2)
WARNING!
Use the electric blanket only with the control provided. The relative model is specified on
the plate sewn on the panel.
- Insert the control inlet (F) into the plug (G) to connect the temperature adjusting control to the electric blanket.
- Repeat the procedure for the second inlet in case of double bed model.
- Disconnect the inlet (F) from the electric blanket by holding the retaining levers on the sides of the plug (G).
PLACEMENT OF ELECTRIC BLANKET (FIG. 1-2)
WARNING!
Only position the electric blanket between the mattress and the first sheet, not directly
on persons in bed.
- Lay the electric blanket (B) directly on the mattress (A) with the side where the plug is located (G) towards
the mattress.
- Do not place the electric blanket under the pillow.
- Make sure the electric blanket is always properly laid out.
- Lay the first sheet (C) on the electric blanket, then make the bed with the sheet (D) and the blanket (E) as
usual.
SWITCHING ON OF THE ELECTRIC BLANKET AND SELECTION OF THE
CORRECT TEMPERATURE
WARNING!
DO NOT place the control under the pillow or sheets during use.
- Plug in the appliance.
- Switch on the electric blanket one hour before going to bed by positioning the temperature adjusting button
on the required level: "1" minimum temperature, "2" medium temperature, "3" maximum temperature.
- When the warning light is on, the appliance is in operation.
- After approximately one hour the bed will be pleasantly warm. Should the room be particularly cold, switch
on the electric blanket two or three hours before lying down.
- Position the control on "0" to switch the electric blanket off.
- Before lying down, position the control onto "0" to switch the electric blanket off and unplug the appliance.
HOW TO GET STARTED
USE
- 9 -
EN