Metalux ADF142140 Instructions D'installation page 3

D. Install plastic lens onto the fixture.
E. Restore power at fuse or circuit breaker box.
Wiring (Rocker Switch - Optional)
CAUTION
Check electrical power wires for damage or scrapes. If
power supply wires are within three inches of ballast use
wire suitable for at least 90°C (194°F).
N ote: Most dwellings built before 1985 have supply wire
rated to 60°C. Consult a qualified electrician before
installing.
A. Remove rectangular knockout from top of ballast cover
(2) before installing rocker switch.
B. Install rocker switch by pressing switch through
knockout.
C. Take black wire from rocker switch and attach it to
the black wire coming from the ballast. Use wire nuts
(included) to attach wiring in steps C through F . See
diagram provided.
D. Attach other rocker switch black wire to incoming black
input supply wire (HOT).
Installation Instructions – Undercabinet Fluorescent Fixture
101653-Mx ADF142140
Installation Instructions – Undercabinet Fluorescent Fixture
E. Attach remaining wires together (white wire from
ballast to white input supply wires - COMMON).
F . Attach ground connection from main power supply (if
available) to green ground wire located inside fixture.
Bulb Replacement
The fixture uses either a T5 lamp or a T8 lamp. See carton
for lamp wattage and information.
FIXTURE
PRE-WIRED
TO SOCKETS
FIXTURE GROUND (GREEN)
www.eaton.com
ROCKER SWITCH
BLACK
BLACK
LOAD
WHITE
WIRE NUT (TYP)
BLACK
HOT
SOURCE
COMMON
GROUND
3