General Specifications - Philips MEMSCAP CPJ840J6 Mode D'emploi

General Specifications

Parameter
Pressure Range (FSO)
Over Pressure (Max)
Sensitivity
Electrical excitation
Input Resistance (Min)
Output Resistance (Max)
Non-linearity (Max)
Zero Balance (Max)
Thermal Sensitivity Shift (Max)
Thermal Zero Shift (Max)
Operating temperature
Storage temperature
Isolation Resistance (Min)
Leak Current (Max)
Weight
Connector
Accessories
Dome Model: CPJ84022, 840-22, 840-34
Line-set Model: CPJ84026
No Degradation or loss of performance due to proximity of RF communication equipment
or electromagnetic disturbances is expected during normal operation.
The Transducer does not utilize RF energy for operation
Detail information regarding accessories is found on page 15
Philips Medical Systems Contacts:
To order Philips Healthcare
supplies online:
http://www.philips.com/healthcarestore
A3 - HHas 04/2020
CPJ840J6
Physiological Pressure Transducer
RoHS compliant according to 2011/65/EU
Range
-30 to 300 mmHg
10 000 mmHg
5 µV/V/mmHg, ±3%
4-8 VDC or -AC up to 5 KHz
200 Ω
3000 Ω
0,5% of FSO
±50 mmHg
0,15%/°C
0,25 mmHg/ °C
+15 to 40°C
-25 to +70°C
1GΩ
1,5 µA @250V, 50Hz
28 gram (without cable)
Equipment specified
PLEASE NOTE:
your trans-ducer has been wired and
calibrated for use with a specific type of
monitor. The J6 transducer has sucess-
fully been tested on the following
monitors:
M1204A with M1006A and M1006B
pressure moduls, M3046A with M3000A
prssure module, M1046A with M1006A
and M1006B pressure moduls.
If you wish to change connector in
order to adapt this transducer to another
type of monitor, please be aware of
possible differences between monitors,
regarding required sensitivity, impe-
dance, AC or DC excitation.
Warning: A change of cables or connectors
may affect the EMC for the transducer.
To locate your local Philips sales
office:
http://ww.healthcare.philips.com
16
30041 rev.10