THOMSON DS120DABCD Mode D'emploi page 22

3. SW Version
Press [ENTER] to view DAB software version. Press Menu or
normal.
*If there are no operations after 30 seconds, the display will return to normal.
Preset
1. Preset Recall
In DAB mode, press
station stored in preset memory.
Note: If you have not previously stored a preset station and the preset button is pressed,
"Empty preset" will be displayed.
2. Preset Store
You may store your preferred DAB stations to the preset station memories. There are 20
memory presets in your radio. Presets are remembered by your radio in the event of a power
failure.
The procedure for setting presets and using them to tune stations is the same for DAB modes:
In DAB mode, select the desired wave band. Press [▲, ▼] to view the stored stations, press
or to tune to the required station as previously described, and then press [ENTER]
to select the desired preset number under which you will store the station. Press [ENTER] to
confirm.
FM Radio
Carefully extend the telescopic aerial to its full length.
Auto Scan
1. Press the [SOURCE] key to select "FM Mode".
2. Long Press
of sufficient signal strength.
3. After a few seconds, the display will update. The display will show the station frequency. If the
signal is strong enough and the station signal contains RDS data, then the radio will display
the station name.
4. To find other stations, press and hold the
5. To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
button and hold for 2 seconds.
6. When the waveband end is reached, your radio will recommence tuning from the opposite
waveband end.
Manual Scan
1. Press the [SOURCE] key on the main unit to select "FM Mode''.
2. Select FM mode as previously described, if required.
or to select "Preset Recall", then press [ENTER] to tune to the
button, and your radio will scan and stop automatically when it finds a station
button as before.
- EN 8 -
. The display will return to