Amplicomms HS 1300 Mode D'emploi page 23

For protection of the transmitter and power saving, the RF signal trans-
mission will be switched Off automatically if there is no audio source
signal for approximately 5 minutes.
Using the optical TOSLINK digital audio cable
If your audio source has an optical audio output (TOSLINK/S-PDIF), connect
the two devices with the included optical TOSLINK digital audio cable. This
connection offers a higher transmission quality and a lower susceptibility to
electrical and magnetic interference.
Please make sure the optical TOSLINK digital audio cable does not get bent
or folded! Avoid tight bending radii.
Connection (Example: analogue input)
(See page 29 for costs and hours of operation)
Helpline UK 0844 800 6503
G
ETTING STARTED
19