Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
Displays
do not illuminate.
The temperature
in the refrigerator
compartment is too
cold.
Floor of
the refrigerator
compartment is wet.
The freezer
compartment has
a thick layer of frost.
Possible cause
Power failure; the fuse
has been switched off;
the mains plug
has not been inserted
properly.
Temperature has been
set too low.
The condensation
channels or drainage
hole are blocked.
Remedial action
In some cases it is adequate
to switch off the appliance
for 5 minutes.
If the temperature is too high wait
a few hours and check whether
the temperature has approached
the set value.
If the temperature is too low check
the temperature again the next day.
Connect mains plug. Check whether
the power is on, check the fuses.
Increase the temperature (see
Selecting the temperature).
Clean the condensation channels
and the drainage hole. See chapter
Cleaning the appliance. Fig. .
Defrost the freezer compartment
(see chapter Defrosting). Always
ensure that the freezer compartment
door is closed properly.
en
35