Switch Setting Table - Pioneer LaserMemory DR-U16S Mode D'emploi

INSTALLATION

SWITCH SETTING TABLE

The display is on the top panel.
Switch 4 - Reserved
MUST BE SET TO OFF (OPEN)
Switch 5: SCSI Terminator
The built-in switch which enables or disables SCSI
termination.
Short = SCSI Termination OFF : SCSI termination disabled
Open = SCSI Termination ON: SCSI termination enabled.
Note: This information is described in detail earlier
in this chapter under SCSI Termination on
page 13.
Switch 6: Default Sector Size
Set the default sector size for the Drive when the drive is
ON.
Short = 512-byte sector size (required for some UNIX
systems)
Open = 2048-byte (2K) sector size (factory default setting)
For PC systems, the recommended setting is OFF (open).
To confirm which sector size should be used in your
system, refer to your system documentation.
Switch 7 - Disable Eject Button
Specifies if the power is ON to the front panel eject button.
Short = Disables the eject button.
Open = Enables the eject button (factory default setting).
Switch 8 - Reserved
MUST BE SET TO OFF (OPEN)
WARNING
The short-circuit switches always must be inserted vertically, never horizontally.
14
<DRC1087>
En
(factory default setting).
2048/512
TERMINATION (SHORT – OFF)
DISABLE EJECT
RESERVED
Switch #
8 7 6 5
RESERVED
SCSI ID
2 1 0
4 3 2 1