Deltec Skimmer 2000ix Instructions D'emploi page 11

position the skimmer in the sump
-
feed water into the skimmer compartment (if applicable)
-
open the water level adjuster (diagram c) fully by turning it anti-clockwise
-
start the skimmer pump
-
close the water level adjuster until fine bubbles are visible between the bayonet and
-
the bottom of the skimmer cup (diagram d)
initially keep the foam level in the skimmer cup low to avoid over skimming and
-
possible flooding of the cup
wait a minimum of 24 hours before the final adjustment
-
turn the water level adjuster in or out until the fine air bubbles start
-
approximately half way up the cups riser tube
for dry foam turn the water level adjuster anti-clockwise
-
for wet foam clockwise
-
Important: Never allow the pump to run dry.
-
Ozone is an extremely aggressive gas which - if not used properly - can damage one's
health. For this reason, ozone should never be breathed in directly.
In addition, at high doses ozone can damage the skimmer.
The dosing of ozone must be set so that no free ozone can be discerned on the skimmer lid.
Deltec skimmers can be operated with between 20 and 50 mg/hours of ozone per pump. An
ozone-resistant T-piece is placed in the air hose above the skimmer pump. The free end of
the T-piece is connected to the ozonizer by means of an ozone-resistant hose.
Height of skimmer compartment
between 180 -290mm
Starting the skimmer
Operation with ozone
-11-
bursting