Cleaning And Maintenance - Perel VTUSC6 Mode D'emploi

not turn on. The unit will idle for about 20 minutes and can be restarted after the
green light [1] comes on.
4. When the heater is needed, press the Temp button [13] to select one of the 5
preset temperatures. Press the TC button [12]; the heater indicator [6] flashes to
indicate that the heater is turned on. The actual water temperature is shown in the
display [7]. When the water reaches the set temperature, the heater and heater
indicator [6] turn off.
Note:
To ensure safe operation, the heater is turned off automatically after 50 minutes.
To speed up mixing and use less solution, use the degas function. Press the Time
button [10] to set the timer to 10 minutes then press the function button [3]; the
heater indicator [6] illuminates. Press the on-off button [2] to start degassing.
The VTUSC6 returns to normal cleaning automatically after 2 minutes.
When debris "smoke" is no longer visible, cleaning is done. If additional cleaning is
needed, reset the timer and repeat the steps above.
5. When cleaning is completed, switch off the VTUSC6 [I], unplug the power cord
[L], open the lid [A] and retrieve the basket [M] and the items. Rinse and dry the
items.
Connect the hose [K] to the drainage pipe [H]. Open the drainage valve [G] to
drain the dirty water. Clean and wipe the tank dry. Do not use abrasive or
corrosive solutions. Close the drainage valve [G].
7.

Cleaning and Maintenance

1. Do not turn on the unit without water in the tank.
Even though the unit is designed with multiple protections, if it is turned on for
over 15 seconds without water in the tank, it may damage the unit or severely
reduce the life of the unit.
2. Do not run the unit for extended time or continuously.
The unit is designed with overheat protection. If the unit has been running for
45 minutes, it is recommended to stop the unit for about 20 minutes to prolong the
life of the unit.
3. Do not keep water in the cleaning tank for a long time.
Remove the water from the tank after each use to prevent the tank from
corroding. Clean and wipe the tank dry.
4. Do not spray water over the housing.
Use a towel to wipe the tank and the housing dry.
5. Do not expose the unit under direct sunshine for a long time.
Keep the unit in a dry, cool and ventilated place.
V. 02 – 17/05/2018
VTUSC6
9 ©Velleman nv